Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

ATM pings

I have 1 router that has 2 atm cards and both connected to a tester(traffic generator) back to back.

I cannot ping the tester, my one side/interface configs are as below:

interface ATM1/0

ip address 192.1.1.1 255.255.255.0

load-interval 30

atm clock INTERNAL

no atm ilmi-keepalive

pvc 1/200

no oam-pvc manage

encapsulation aal5snap

!

end

the tester has a pvc 1/200

ip address 192.1.1.2 255.255.255.0

what could be a problem since I can't ping the tester?

  • WAN Routing and Switching
1 REPLY
Hall of Fame Super Silver

Re: ATM pings

Hello Lawrence,

be aware that not always a traffic generator answers to ping on the interface.

Also it is not sure it supports inverse ARP.

You can try to add a mapping with

pvc 1/200

protocol ip 192.1.1.2

because you are using the physical interface

I would suggest you to perform tests by configuring the traffic generator to send traffic with destination on the other tester port.

if you see the rx counters on port2 incrementing while sending traffic with port1 you should be fine

Hope to help

Giuseppe

170
Views
0
Helpful
1
Replies
This widget could not be displayed.