Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Gold

ATM PVC between Lucent & Cisco

Anyone know of any problems or restrictions concerning configuring an atm pvc between a lucent switch and a cisco mgx ?

2 REPLIES
Silver

Re: ATM PVC between Lucent & Cisco

An ATM interface might stick in the state "going down" if the PVC is created from the ATM router module with VCI "34" on the ATM side. For example, "atm pvc 2 35 pd on interface ATM0/0/0 7 34" causes the line to flap "up" and "down". Refer the URL

http://www.cisco.com/en/US/products/hw/switches/ps718/prod_release_note09186a008041fac6.html#wp826935

Re: ATM PVC between Lucent & Cisco

Hello,

What are the traffic parameters (PVC type like CBR UBR VBR ABR, PVC settings like PCR, SCR, burst sizes, etc., OAM management, ILMI management)? Make sure they are matching. The MGX follows the standard parameters from the ATM forum externally.

What line parameters are required? Make sure they match. Besides those "match conditions" ATM should behave fine.

Regards, Martin

188
Views
0
Helpful
2
Replies
CreatePlease to create content