02-10-2010 12:20 AM - edited 03-04-2019 07:27 AM
Dear All,
I have existing 3745 router with "NM-4E1-IMA" card and need the same card on 3845 & 3945 router. I have checked card replacement docs of this card and found "AIM-ATM-4T1/E1" card as replacement for 3845 router.
I am not getting any document which provides card replacemnt info for 3945 series router.
I need 2 or 4-port E1 ATM Network Module with IMA OR any module which fulfills the need of this requirement on 3945 router.
Our WAN links are E1 links and configuration is done under ATM interface.
Any 1 or 2 E1 port module with ATM. Please suggest.
Thanks,
Nitin
Solved! Go to Solution.
02-10-2010 03:02 AM
Hello Nitin,
I'm afraid the only ATM interface supported are T3/E3 or OC3
see
http://www.cisco.com/en/US/prod/collateral/routers/ps10538/aag_c07_563807.pdf
modules AIM are listed under the unsupported list.
But the new routers have a different module already installed that might be used with the E1/T1 VWIC2
see also Q&A
Hope to help
Giuseppe
02-10-2010 03:02 AM
Hello Nitin,
I'm afraid the only ATM interface supported are T3/E3 or OC3
see
http://www.cisco.com/en/US/prod/collateral/routers/ps10538/aag_c07_563807.pdf
modules AIM are listed under the unsupported list.
But the new routers have a different module already installed that might be used with the E1/T1 VWIC2
see also Q&A
Hope to help
Giuseppe
02-10-2010 03:19 AM
Thanks Giuseppe,
I already had this info and was looking for something which solves the issue. so this new ISR2 routers will not support ATM services with E1/T1 at all.
anyway thank you very much for your help.
regards,
Nitin
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide