ATM to FR, ping is ok, EIGRP - Retry Limit Exceeded
Hi, I have problem with translation Frame Relay to ATM, I will copy my config from ATM router and FR router, ping is ok, I can ping other side perfect but EIGRP all the time do EIGRP - Retry Limit Exceeded. What I missing in configuration ? This is test so i dont have nothing configure about CIR , Bandwith limit itd.. only I need to get that this work and later i will with ISP configure CIR.
Re: ATM to FR, ping is ok, EIGRP - Retry Limit Exceeded
it looks like that when using point-to-point FR to ATM service interworking does not transport the multicast ip over the FR DLCI: it is the atm side that does not receive and then sends the goodbye message to close the session
int ser0/0/0.50 point-to-point
frame-relay interface-dlci 50
frame-relay map ip 192.168.1.1 50 broadcast
! if the second is not allowed remove the first and put only the second
or try to use neighbor commands under the router eigrp process on both routers
router eigrp 10
router eigrp 10
in this way you instruct the routers to use unicast packets to exchange hellos and updates
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.