08-23-2007 07:48 AM - edited 03-03-2019 06:26 PM
How do I add the following command to a 2811?
interface ATM1/0
description 26HCGJXXXXXX
no ip address
ip nbar protocol-discovery
no atm ilmi-keepalive
no scrambling-payload
Solved! Go to Solution.
08-24-2007 08:47 AM
Is the problem you're not seeing your ATM interfaces? What you might need to do is configure the controller to indicate you're using ATM. Something such as:
controller T1 0/0/0
mode atm aim 0
framing esf
clock source line primary
linecode b8zs
!
controller T1 0/0/1
mode atm aim 0
framing esf
linecode b8zs
!
controller T1 0/1/0
mode atm aim 0
framing esf
linecode b8zs
!
controller T1 0/1/1
shutdown
framing esf
linecode b8zs
08-24-2007 05:47 AM
conf t
paste that in
profit!
assuming, of course, that you have some sort of ATM interface on the 2811. I can't answer that for you as I have never ever used ATM in a 2811.
08-24-2007 08:47 AM
Is the problem you're not seeing your ATM interfaces? What you might need to do is configure the controller to indicate you're using ATM. Something such as:
controller T1 0/0/0
mode atm aim 0
framing esf
clock source line primary
linecode b8zs
!
controller T1 0/0/1
mode atm aim 0
framing esf
linecode b8zs
!
controller T1 0/1/0
mode atm aim 0
framing esf
linecode b8zs
!
controller T1 0/1/1
shutdown
framing esf
linecode b8zs
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: