I can turn off auto negotiation on a fiber/Gig interface on a 3825 router by the command:
no negotiation auto
What does this buy me as in any case it will be full / 1000? What kind of (negotiation) traffic should I see with negotiation turned on on the router?
I'm troubleshooting an issue where the link between a 3825 router and a 6509 switch works fine with negotiation on on router and turned off on switch. When I put an IPS in line between the router and switch, link fails. IPS is configured with negotiation off.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...