Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Auto Qos on MultiLink PPP or FrameRelay

Can you run Auto Qos on Multilink PPP or Frame-Relay MFR Multilink groups where you have multiple T1's bonded? Or would I have to setup QOS manually? This will be used to give priority to Cisco IP Phones.

2 REPLIES

Re: Auto Qos on MultiLink PPP or FrameRelay

Hi JIM,

Q. What interfaces currently support Cisco AutoQoS?

A. Router platforms: Cisco serial (PPP/HDLC), Frame Relay DLCIs and ATM VCs on the router platforms

http://www.cisco.com/en/US/technologies/tk543/tk879/technologies_qas0900aecd8020a589_ps6613_Products_Q_and_A_Item.html

HTH

Thot

New Member

Re: Auto Qos on MultiLink PPP or FrameRelay

That Still doesn't specifically answer whehter it is supported on Multilink PPP or Multilink Frame-Relay (MFR). It looks like I can add the Auto QOS commands under the DLCI's and the multiple physical interfaces for MultiLink PPP setup but not the multilink groups themselves. Is this the correct way to set this up?

1147
Views
0
Helpful
2
Replies
CreatePlease to create content