09-05-2006 08:33 PM - edited 03-03-2019 01:53 PM
i want to access my remote router console using aux port by modem can someone help me to provide what configuration has to be done in both end
any help highly appreciated
09-05-2006 08:36 PM
10-05-2006 12:01 AM
Paresh
i hve some issues
here it is my aux port config on 2800 router
line aux 0
exec-timeout 0 0
privilege level 15
password XXXXX
login local
modem InOut
modem autoconfigure discovery
no exec
transport input all
autoselect during-login
stopbits 1
speed 57600
flowcontrol hardware
while i am trying to access through my remote end using hyper terminal i am able to connect but my hyper terminal still showing blank
can yoy help me to sort out this problem
regards
10-06-2006 12:34 AM
Hi
Assuming you have a POTS line connecting to modem which gets connected to Aux port
Open a normal hyperterminal session
Type AT and enter
then ATD
It will dial the digits through the modem and give you the prompt
HTH
Narayan
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: