Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

back the switch to the default configuration

Hi All

how can i back the switch to the default configuration.this is maean erase the startup-config or what.also i need information about the pvst+

5 REPLIES
Purple

Re: back the switch to the default configuration

To restore an IOS-based router/switch to factory default, issue the command 'write erase' and then reload the box - answer 'no' if it asks you to save the configuration.

Pls do remember to rate posts.

Paresh.

New Member

Re: back the switch to the default configuration

10xs for ur reply!

but what about the pvst+ documentation and configuration.

10xs

Ali

New Member

Re: back the switch to the default configuration

10xs for ur reply!

what about the pvst+ documentation + configuration!

10xs

Ali

Re: back the switch to the default configuration

Hi Ali,

I have already posted the doc for configuring STP

Have this doc again

http://www.cisco.com/univercd/cc/td/doc/product/lan/c3550/12120ea2/3550scg/swstp.htm#wp1082107

By default cisco switches run PVST+

HTH, if yes please rate the post.

Ankur

Re: back the switch to the default configuration

Hi Friend,

In addition to Paresh post to answer your second question all the cisco switches by default run PVST+ mode.

To read more about PVST+ you can read this link

http://www.cisco.com/univercd/cc/td/doc/product/lan/c3550/12120ea2/3550scg/swstp.htm

HTH, if yes please rate the post.

Ankur

85
Views
6
Helpful
5
Replies