Back to back G.SHDSL configuration

[h.botha]

Hi all

I have 2 X cisco 2811 routers with hwic-2shdsl cards

I need to setup a SHDSL back to back connection.

IOS ver 12.4(11)xj

I have a RJ11 cable plugged into both SDSL interfaces - i just need a sample config to continue.

Can anyone help me?

Regards

Hennie

[mohammedmahmoud]

Hi,

Please refer to the following document:

http://www.cisco.com/en/US/tech/tk175/tk274/technologies_configuration_example09186a0080135834.shtml

HTH,

Mohammed Mahmoud.

[h.botha]

Hi Mohammed,

I looked at this document previously, there are a number of commands that are not supported on my combination of hardware/IOS.

- DSL Equipment type- etc

Any other ideas

cheers

Hennie

[mohammedmahmoud]

Hi,

No, i guess that your only chance is to use the appropriate IOS to have it done.

HTH,

Mohammed Mahmoud.

[h.botha]

Hi Mohammed,

Thanks i have checked - the only ios to support the hardware configuration is 12.4(11)xj.

Which is cuurently on the hardware.

Regards

Hennie

[mohammedmahmoud]

Hi,

Weird ! i've tried this configuration once before on a Cisco 2600 series running 12.3T, and it worked (the "dsl equipment-type" command is applied under the interface not on the global configuration mode), any way i'll try testing it on a 2800 router and feed you back.

HTH,

Mohammed Mahmoud.

[h.botha]

Hi,

I will await your feedback/testing.

Regards

Hennie

[lvigh]

Hi, Hennie

I have the same problem as You. Do you have any solution?

Best Regards,

Loj

[abolfathi_0248]

Hi

i have same problem.it take too much time for me.i think the problem are :

1-you need to upgrade your current IOS to 12.4T(6) or later.

2-i think only Cisco ISR-878 G.SHDSL and old G.SHDSL-v3-WIC (not HWIC) support back-to-back

3-FAQ for G.SHDSL HWIC mentioned that back-to-back only supported on 4-pair G.SHDSL only to diagnostics perpose.

4-i am wonder while G.SHDSL HWIC use the same ITU G.991.2 standard , why back-to-back not supported