Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Back to back G.SHDSL configuration

Hi all

I have 2 X cisco 2811 routers with hwic-2shdsl cards

I need to setup a SHDSL back to back connection.

IOS ver 12.4(11)xj

I have a RJ11 cable plugged into both SDSL interfaces - i just need a sample config to continue.

Can anyone help me?

Regards

Hennie

8 REPLIES

Re: Back to back G.SHDSL configuration

New Member

Re: Back to back G.SHDSL configuration

Hi Mohammed,

I looked at this document previously, there are a number of commands that are not supported on my combination of hardware/IOS.

- DSL Equipment type- etc

Any other ideas

cheers

Hennie

Re: Back to back G.SHDSL configuration

Hi,

No, i guess that your only chance is to use the appropriate IOS to have it done.

HTH,

Mohammed Mahmoud.

New Member

Re: Back to back G.SHDSL configuration

Hi Mohammed,

Thanks i have checked - the only ios to support the hardware configuration is 12.4(11)xj.

Which is cuurently on the hardware.

Regards

Hennie

Re: Back to back G.SHDSL configuration

Hi,

Weird ! i've tried this configuration once before on a Cisco 2600 series running 12.3T, and it worked (the "dsl equipment-type" command is applied under the interface not on the global configuration mode), any way i'll try testing it on a 2800 router and feed you back.

HTH,

Mohammed Mahmoud.

New Member

Re: Back to back G.SHDSL configuration

Hi,

I will await your feedback/testing.

Regards

Hennie

New Member

Re: Back to back G.SHDSL configuration

Hi, Hennie

I have the same problem as You. Do you have any solution?

Best Regards,

Loj

New Member

Re: Back to back G.SHDSL configuration

Hi

i have same problem.it take too much time for me.i think the problem are :

1-you need to upgrade your current IOS to 12.4T(6) or later.

2-i think only Cisco ISR-878 G.SHDSL and old G.SHDSL-v3-WIC (not HWIC) support back-to-back

3-FAQ for G.SHDSL HWIC mentioned that back-to-back only supported on 4-pair G.SHDSL only to diagnostics perpose.

4-i am wonder while G.SHDSL HWIC use the same ITU G.991.2 standard , why back-to-back not supported

947
Views
0
Helpful
8
Replies