Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

Back to Back routers

I'm having the hardest time trying to do something so simple. I'm connecting two routers (1721 and 2621) together with DCE and DTE cables connected to each other.

What commands do I use to get them to talk? I've got 'Interface UP, Protocol DOWN' on both of them...

Please help!

2 REPLIES
Purple

Re: Back to Back routers

Hi,

On the router to which the DCE cable is connected, issue the following command under the serial interface:

'clock rate '

Choose a bit-rate applicable to your setup.

Hope that helps - pls rate the post if it does.

Paresh

New Member

Re: Back to Back routers

Hi there, what bit rates would people normally set up ?

142
Views
5
Helpful
2
Replies
CreatePlease to create content