Backhaul and route remote site to other WAN sites.
I am hoping someone can assist with the necessary ip routes to be able to route traffic between a subnet which is backhauled over a wireless link to another site which is connected to the rest of our WAN.
The remote site is 172.16.26.0/24. It is being backhauled to 172.16.25.0/24. 172.16.25.0/24 is accessible to all sites in 172.16.24.0/21.
However, 172.16.26.0/24 is only accessible from 172.16.25.0/24.
The main objective here is to make 172.16.26.0/24 accessible from all sites.
10.252.0/24 is our provider's private IP network (connecting all our other WAN sites)
Our private IP provider is using RIPv2 between our sites and we are using a single ip route of 172.16.24.0/21 on all our branch office routers to use our private IP provider's designated gateway e.g. ip route 172.16.24.0 255.255.248.0 10.252.0.5
A Cisco 891 has been used to connect our branch offices to our private IP provider's network and 2 x Cisco 881's have been used between the wireless endpoints.
[toc:faq]The ProblemOn traditional switches whenever we have a trunk
interface we use the VLAN tag to demultiplex the VLANs. The switch needs
to determine which MAC Address table to look in for a forwarding
decision. To do this we require the switch to do...
[toc:faq]Introduction:Netdr is a tool available on a RSP720, Sup720 or
Sup32 that allows one to capture packets on the RP or SP inband. The
netdr command can be used to capture both Tx and Rx packets in the
software switching path. This is not a substitut...
IntroductionOSPF, being a link-state protocol, allows for every router
in the network to know of every link and OSPF speaker in the entire
network. From this picture each router independently runs the Shortest
Path First (SPF) algorithm to determine the b...