Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Backup ISDN auto disconnected

Hi

I would know if there is a command that permit to configure auto disconnect the backup isdn interface, after that the interface try for 3 times to connect without success.

3 REPLIES
enc
New Member

Re: Backup ISDN auto disconnected

I am not able to test this, but it might be an idea:

On serial interfaces you can use " dialer enable-timeout" with a max value of 2147483 which is a lot of days.

You can not use this command with the purpose you have direcly on an ISDN interface, but I would expect you could use is on a Dialer interface.

(ISDN interfaces are not held down after a call has failed or completed because these interfaces support several possible calls at a time)

interface Dialer1

description ISDN

bandwidth 64

ip address

encapsulation ppp

dialer pool 1

dialer idle-timeout 180

dialer enable-timeout 2147483

dialer string 1234567890

dialer-group 1

interface BRI1/0

no ip address

encapsulation ppp

dialer pool-member 1

:-)

New Member

Re: Backup ISDN auto disconnected

Thanks you for answer. Now I'm studing the command dialer enable-timeout... if there is good news I'll write here ;)

New Member

Re: Backup ISDN auto disconnected

Hi,

At Serial interface try "backup interface dialer0" and set delay to get dialer to be fired by "backup delay 5 5" both commands to be configured at serial interface also put floating static routes i.e 0.0.0.0 0.0.0.0 Serial 0

0.0.0.0 0.0.0.0 dialer 0 50

This will enable the backup configuration

and put the "dialer ideal-timeout 100" at dialer interface.

Hope this can help u out.

rgds,

Hardik..

127
Views
0
Helpful
3
Replies
CreatePlease login to create content