backup link test

[harinirina]

Hi everybody,

I've tested the attached backup link configuration (conf_test.txt) using 2 routers with VWIC 2T on each, connected by CAB-SS-2626X.

Actually, we should use T2 as main link and leased line as backup.

The current config on the router where i should configure after testing is also attached here (current_conf.txt).

I'd like to know how can I simulate this scenario before configuring it on a live network?

is there any change to do on the test config when we use T2 and LL

[mastram4u]

As you did in the test config, you need to specify the route without AD for the primary and with AD for the backup link.

Hope that helps.

[harinirina]

Thanks for the reply.

in the live network, we use VWIC-1MFT-E1 but not VWIC-2T.

I'd like to ask you if there's some modification to do in the config when i use other card or other protocol