Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

backup link test

Hi everybody,

I've tested the attached backup link configuration (conf_test.txt) using 2 routers with VWIC 2T on each, connected by CAB-SS-2626X.

Actually, we should use T2 as main link and leased line as backup.

The current config on the router where i should configure after testing is also attached here (current_conf.txt).

I'd like to know how can I simulate this scenario before configuring it on a live network?

is there any change to do on the test config when we use T2 and LL

2 REPLIES
New Member

Re: backup link test

As you did in the test config, you need to specify the route without AD for the primary and with AD for the backup link.

Hope that helps.

New Member

Re: backup link test

Thanks for the reply.

in the live network, we use VWIC-1MFT-E1 but not VWIC-2T.

I'd like to ask you if there's some modification to do in the config when i use other card or other protocol

118
Views
0
Helpful
2
Replies
CreatePlease to create content