Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Community Member

Backup static route using object tracking

I have two 1841 routers at two sites with a point to point T1 connecting them. They each have an Internet connection that the local site uses for their primary connectivity. I want to configure each router to use the other for backup in case their ISP connection goes down. I wanted to use static routing backup using object tracking but I am running an IP Base image and this feature is not available.

R1(config)#track 1 rtr

                    ^

% Invalid input detected at '^' marker.

Is there another way of doing this or do I need to upgrade?
Thanks,
-mike

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Re: Backup static route using object tracking

Hi,

On 1841, only Advanced IP or ServiceProvider feature set support Reliable Static Routing Back-up using Object Tracking .

You need to upgrade your IOS to AdvancedIP or SP feature set.

You can download Adv.IP or SP feature set IOS from below link if you have a valid CCO ID.

http://www.cisco.com/cisco/psn/web/download/index.html

KK.

1 REPLY
Cisco Employee

Re: Backup static route using object tracking

Hi,

On 1841, only Advanced IP or ServiceProvider feature set support Reliable Static Routing Back-up using Object Tracking .

You need to upgrade your IOS to AdvancedIP or SP feature set.

You can download Adv.IP or SP feature set IOS from below link if you have a valid CCO ID.

http://www.cisco.com/cisco/psn/web/download/index.html

KK.

279
Views
0
Helpful
1
Replies
CreatePlease to create content