Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Bandwidt Points

Hi,

Can anybody tell me regarding the bandwidth points of 7206-NPE-G2.

Best Regards,

Rahim

2 REPLIES
Silver

Re: Bandwidt Points

AFAIK there is no difference in the bandwidth points offered on NPE-G2 it is the same 600 points as in the good old NPE-G1

As quoted in http://cisco.com/en/US/products/hw/modules/ps2033/products_configuration_guide_chapter09186a008014cf5c.html#wp1053970

NPE-G1 or NPE-G2

?Left side, bus 1 (slots 1, 3, and 5) and I/O controller (slot 0) has a 600 point maximum.

?Right side, bus 2 (slots 2, 4, and 6) has a 600 point maximum.

?Distribute port adapter bandwidth points evenly across both left and right system slots (buses).

?Do not calculate bandwidth points for an I/O controller if an I/O controller is installed with the NPE-G1 or NPE-G2.

?The NPE-G1 or NPE-G2 Gigabit Ethernet interfaces do not use bandwidth points.

Silver

Re: Bandwidt Points

This attached document describes the requirements for the port adaptors for the 720x routers. Each WAN/LAN PA eata up a certain amount of bandwidth points. This doc explains it....Good Luck.....

156
Views
0
Helpful
2
Replies