Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

bandwidth 9k when show interface tunnel 0.

Hi.

I wonder if when I try to get the output of interface tunnel0. it displays as following.

show interface tunnel 0

the tunnel is up and up

bandwidth 9k

My questions is that bandwidth 9k show I issued show interface tunnel 0means that is the real bandwidth is 9k?.

so far I've known, bandwidth is just value when it refers on routing protocol path calculation.

1 ACCEPTED SOLUTION

Accepted Solutions
Super Bronze

Re: bandwidth 9k when show interface tunnel 0.

Disclaimer

The    Author of this posting offers the information contained within this    posting without consideration and with the reader's understanding that    there's no implied or expressed suitability or fitness for any  purpose.   Information provided is for informational purposes only and  should not   be construed as rendering professional advice of any kind.  Usage of  this  posting's information is solely at reader's own risk.

Liability Disclaimer

In    no event shall Author be liable for any damages whatsoever  (including,   without limitation, damages for loss of use, data or  profit) arising  out  of the use or inability to use the posting's  information even if  Author  has been advised of the possibility of such  damage.

Posting

Is it "real"?  Depends on what's actually supporting the tunnel; likely not.  You're correct it might be used by routing path calculation (or not), might be used by other features too.  This is also true for other interfaces too, i.e. interface bandwidth displayed (or set via a bandwidth statement) doesn't necessarily reflect actual interface bandwidth.

1 REPLY
Super Bronze

Re: bandwidth 9k when show interface tunnel 0.

Disclaimer

The    Author of this posting offers the information contained within this    posting without consideration and with the reader's understanding that    there's no implied or expressed suitability or fitness for any  purpose.   Information provided is for informational purposes only and  should not   be construed as rendering professional advice of any kind.  Usage of  this  posting's information is solely at reader's own risk.

Liability Disclaimer

In    no event shall Author be liable for any damages whatsoever  (including,   without limitation, damages for loss of use, data or  profit) arising  out  of the use or inability to use the posting's  information even if  Author  has been advised of the possibility of such  damage.

Posting

Is it "real"?  Depends on what's actually supporting the tunnel; likely not.  You're correct it might be used by routing path calculation (or not), might be used by other features too.  This is also true for other interfaces too, i.e. interface bandwidth displayed (or set via a bandwidth statement) doesn't necessarily reflect actual interface bandwidth.

448
Views
0
Helpful
1
Replies
CreatePlease login to create content