Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

Bandwidth check for wan router

Hai all,

I have one wan router, which is connecting between two sites using service provide MPLS link and we created tunnel between these two sites for interconnection. Now, i have a simple doubt for checking the bandwidth of remote site. is there any Option, i mean the bandwidth which is provided by service provide to Wan router. Please let me know the different option if any???

Everyone's tags (3)
1 REPLY
Silver

Bandwidth check for wan router

you can generate traffic between the 2 sites (file transfer for example) then use show interface command to check for speed by looking to : 5 min input/output.

but you need to wait for 5 min to get accurate result. you can also change this value: under interface tunnel you type: load-interval 30 (to get the value of 30s)

if you are familiar with SNMP you can also use some free software like PRTG to measure interface speed.

876
Views
0
Helpful
1
Replies
CreatePlease to create content