Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Bandwidth Cmd

Dear,

I have a Cisco 3845 and one of its Serial Ports is connected to the DR Site.I want to make sure that the link is really 2MBps or not. Is there a show command that would show this type of info?

Thanks

swami

4 REPLIES
Silver

Re: Bandwidth Cmd

Hi,

On some serial interfaces you can use the show controller serial x command, to find out what the clock rate is for the line.

The clock rate is the actual BW of the link.

I havent seen it on all interfaces so you might not see it on yours, but give it a shot!

HTH

LR

New Member

Re: Bandwidth Cmd

you can run show controllers device attached

Ex:

show controllers serial0/1

should also tell if DTE/DCE

Re: Bandwidth Cmd

try to use show running-config interface serial command. this will show the configured bandwidth of your serial link. if nothing shows, you have to configure bandwidth <2000> (bw in kbps)interface configuration command

Hall of Fame Super Silver

Re: Bandwidth Cmd

Hello John,

be aware that the bandwidth command you can configure under a serial interface is unrelated to the real link speed.

It can be used for:

routing protocols like OSPF and EIGRP to change the metric calculations for the link

in Modular QoS to provide the reference value for the bandwidth and priority percent commands in the police-maps

to change the link speed on the DCE side you use clock rate

Hope to help

Giuseppe

126
Views
6
Helpful
4
Replies
CreatePlease login to create content