What Paolo said above is correct. The aggregate Internet Service bandwidth that you have is 20Mbps. But since each link to your ISP(s) are 10Mbps, you're only going to get 10Mbps speed max on each link, but you will be able to accomdate 20Mbps total when you combined both, if you get what I"m saying.
Think about having a two lane road, where each car can only go 10mph. You can have a total of 20mph speed on the road, but each car can only do 10mph on each road.
With BGP, usually you receive on of several things
- Full Route Table
- Partial Table (Usually just your providers routes)
- Default Route
If you have access to the router that runs bgp, if you run 'show ip bgp' you will be able to see this
If it's a default route you will see something like *>0.0.0.0/0
If it's a Partial Table you will see numerous routes but not like you would on a full BGP table. Usually you will see routes from your providers networks and a default route, going to their upstream provider
If it's a full table, you will see routes starting from something like *>22.214.171.124/x And so on up to the max.
Hope this helps some.
You can always load balance links, and prefer this set of routes on this links and this set of routes out the other.
But that's all up to how you want to set things up, and how best fits your organization.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.