Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

bandwidth command for subinterfaces with shaping

Does anyone know why the bandwidth statement on the subinterface would be ignored unless its applied to the main interface? In a head-end setup i may have additional subs and I would think the bandwitch statement on the main int should reflect the actual bandwidth while the subs woudl reflect their individual allocation.. Config:

policy-map main-policy
class voice-class-map
  bandwidth percent 20
class video-class-map
  bandwidth percent 30
class management-class-map
  bandwidth percent 5
class critical-class-map
  bandwidth percent 25
  queue-limit 1024 packets
  random-detect
class class-default
  bandwidth percent 5
  queue-limit 1024 packets
  random-detect
policy-map traffic-shape-policy
class class-default
  shape average percent 90
  service-policy main-policy
!
int gi0/0
desc WAN
speed 100
duplex full
bandwidth 50000
!
int gi0/0.100
encap dot1q 100
ip 1.1.1.1 255.255.255.0
service-policy out traffic-shape-policy
bandwidth 50000


Thanks!

Everyone's tags (4)
2 REPLIES

bandwidth command for subinterfaces with shaping

To configure bandwidth to be used as a reference for calculating rates of quality of service (QoS) percent configurations on a physical or logical interface, use the bandwidth qos-reference command in interface configuration or subinterface configuration mode.

http://www.cisco.com/en/US/docs/ios/qos/command/reference/qos_a1.html#wp1027485

regards,

Leo

New Member

Re: bandwidth command for subinterfaces with shaping

Thanks for the reply Leo. I’ll give this a look..

2941
Views
5
Helpful
2
Replies