This is a lab enviroment.The network diagram is in the attachment.PC1 is in Vlan2.The Cisco router has a default route set:
ip route 0.0.0.0 0.0.0.0 192.168.1.1.
I want to limit the bandwidth, input & output, on Vlan 2 interface to 2 Mbps only.
#police 2000000 conform-action transmit exceed-action drop
#int vlan 2
#service-policy input bandwidth_limit
#service-policy output bandwidth_limit
Now, as i understanded well what does CB Policing does, traffic from PC1 if does not exceed 2Mbps will be transmited
and packets that exceed 2Mbps will be droped,having this configuration on the router.
I use the Wan Killer utility, from SolarWinds Engineer Toolset, to generate 7Mbps from PC1(this info is from Network Limiter Bandwidth Monitor) traffic(UDP 7 Echo segments)to destination IP 192.168.1.1.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.