I am facing some issues with XR device.If i insert ATM/POS module in to XR device with XR ver 3.6.3 working fine.If i change to 3.8.0 ATM cards not coming up and showing LOW MEM. the same for POS line cards also. Even few SIP 12000-SIP-600 the same!
In IOS devices 12K
ATM module coming up but after few mins card going down showing BANDWIDTH LOW!
Can you please help me in fixing such issues! These are really blocking my configuration works! i tried with PRP2 with 4 GB MEM and PRP1 also issues remain same even iam using 2 CSC and 4 to 3 SFC. Does i need to consider the slots for PRP and line cards? most of the time card going to reset state! please help!!!!
Cisco supports the deployment of Cisco IOS XR software on the following route processors (RPs) installed in a Cisco XR 12000 Series Router:
and for linecards
Minimum Line Card Memory Requirement
To operate properly, Cisco IOS XR software requires that a line card have a minimum of 1 GB of memory.
Because not all Engine-5 and Engine-3 line cards are configured with this amount of memory, you must manually confirm the memory level of the line cards against the current minimum memory requirement before migration.
Probably memory requirements have been increased in IOS XR 3.8 in comparison with IOS XR 3.6
We are pleased to announce availability of Beta software for 16.6.3. 16.6.3 will be the second rebuild on the 16.6 release train targeted towards Catalyst 9500/9400/9300/3850/3650 switching platforms. We are looking for early feedback from custome...