Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

bandwidth measurement

Hi,

is ther any command in cisco routers to find the bandwidth over serial interface with out any third pary tool

4 REPLIES
Cisco Employee

Re: bandwidth measurement

Hi,

You can use " show interface serial x/y" and check the input/ output packet rate. This will give you an idea of how much the bandwidth is used in RX and TX. The output is an average of 5 minutes interval. If you want to change the interval to take some more granular readings, chnage the interval like :

conf t

int serial x/y

load-interval 30--> seconds

HTH,

-amit singh

New Member

Re: bandwidth measurement

Hi ,

i want exact current bandwidth to measure at that second through serial interface,any command is there.

Re: bandwidth measurement

Hi Siva

I feel you can also try out some NMS solution which can provide you the utilisation part..

Lots of freewares available in net which you can download and configure it accordingly..

regds

Silver

Re: bandwidth measurement

Try this file I made. It has a listing of the bandwidth associated with the load value on the interface. This chart will show you what you want to see....

241
Views
5
Helpful
4
Replies