Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

Bandwidth of tunnel Interface

Please what is the bandwidth of a tunnel interface as seen by routing protocols like eigrp and ospf.

2 REPLIES

Re: Bandwidth of tunnel Interface

Hi Kennie,

The bandwidth of tunnel interface configured using bandwidth command just indicates the value assumed to be available by routing protocols etc for metric calculation.

The actual bandwidth is dependent on the line rate (actual rate of sending bits) of the physical interface (acting as tunnel source).

HTH

Lejoe

Re: Bandwidth of tunnel Interface

Bandwidth chosen is the one that is set under the tunnel interface.

By default the tunnel bandwidth is 9k so the protocols will use 9k as the bandwidth if you have not set one

HTH

Narayan

195
Views
0
Helpful
2
Replies
CreatePlease to create content