Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Bandwidth (QOS) command is not taking in the Giga interface

HI all,

  While applying service policy command in out direction in cisco 7609 Router, I am getting following error. "bandwidth percent command is not supported in output direction for this interface Configuration failed!".Even I have changed the bandwidth percentage command to Kbps value.Then also I am getting error.

class-map match-any TESTQOS
  match access-group name testdata

class-map match-all test1
  match access-group 2005

Class-map default
fair que
!
policy-map QOS
  class TESTQOS
   bandwidth percent 40
    class test1
   bandwidth percent 20

ip access-list extended testdata
permit ospf any any
permit esp any any

Service-policy output QOS

Thanks a lot in advance....

Regards,

Mahesh

1 REPLY
New Member

Re: Bandwidth (QOS) command is not taking in the Giga interface

sorry pls find the error...

testrouter(config)#int Gi2/5


testrouter(config-if)#service-policy output QOS

bandwidth percent command is not supported in output direction for this interface Configuration failed!

379
Views
0
Helpful
1
Replies
CreatePlease to create content