Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Bandwidth report of one host on router

Hi, I have one 7200 Series router and I have internal network 10.32.0.0/16 for data and 10.35.0.0/16 for voice. We have MPLS for external link having BGP on that.  I have configured QOS polices for Voice and Data network. I have Solarwind as NMS which is monitoring the links and giving detail of bandwidth utilized on the interface.

Now I have installed on SQL application in inside network, 10.32.111.15 IP. I want to know how much WAN bandwidth this application is taking.

How can I do it ? Any idea?

Regards,

Rupesh

6 REPLIES
Hall of Fame Super Silver

Re: Bandwidth report of one host on router

Hello Rupesh,

an ACL with log option or ip accounting output-packets on exit interface.

wait some time then issue

sh ip accounting | inc 10.32.111.15

doing this over time you can get a measure of traffic originated by this ip address

other ideas are possible like using netflow to get top talkers information

Hope to help

Giuseppe

Hall of Fame Super Bronze

Re: Bandwidth report of one host on router

You can create a class-map to match the source IP address for this server.

You can refer to this class-map under the policy-map and provide CBWFQ for this application.

Doing so will create a separate category for this application so you can use your NMS appliance for tracking purposes.

For instance:

access-list 99 permit host 10.32.111.15

class-map SQL

match access-group 99

policy-map WAN-QOS

class SQL

bandwidth percent 10

interface fx/x

service-policy out WAN-QOS

Regards

Edison

New Member

Re: Bandwidth report of one host on router

Ok, If I will apply QOS, then how I can take out the report?

Hall of Fame Super Silver

Re: Bandwidth report of one host on router

Hello Rupesh,

you can use

sh policy-map int f0/0

you will get rates and cumulative counters for each traffic class including the SQL class

Hope to help

Giuseppe

New Member

Re: Bandwidth report of one host on router

Ok, below I have configure 60% bandwidth for SQL. How can I calculate the bandwidth used by this, what would the time interval.

Class-map: SQL (match-any)
      1294224644 packets, 101573999974 bytes
      5 minute offered rate 830000 bps, drop rate 0 bps
      Match: access-group name Citrix
        1294224642 packets, 101573999743 bytes
        5 minute rate 830000 bps
      Queueing
      queue limit 1024 packets
      (queue depth/total drops/no-buffer drops) 0/0/0
      (pkts output/bytes output) 13429021/1062276628
      bandwidth 60% (6000 kbps)
      QoS Set
        dscp af42
          Packets marked 1294224647

Hall of Fame Super Bronze

Re: Bandwidth report of one host on router

Your output indicates a 5min average of 830kbps (5 minute offered rate 830000 bps, drop rate 0 bps)

You may want to change the load-interval in the interface(s) to 30seconds to get a better read on the bandwidth consumed by the application.

Regards,

Edison

575
Views
5
Helpful
6
Replies
CreatePlease login to create content