Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

Bandwidth upgrade

We're in the process of upgrading a circuit from 256 Mb to a t-1. I've verified that the hardware is fine (though we will be upgrading hw at a later time), but have a question on the config. The only thing I would need to change on the config is serial interface, bandwidth to 1536, correct? The router is 1751, IOS 12.2(11)T10.

Thanks,

C

6 REPLIES
Community Member

Re: Bandwidth upgrade

the bandwidth command will not change the speed of the interface. Please post the relevant info from your config.

Community Member

Re: Bandwidth upgrade

Here's our current serial interface:

interface Serial0/0

description cir: 34.HCGS.416547

bandwidth 256

no ip address

encapsulation frame-relay IETF

no fair-queue

service-module t1 timeslots 1-4

frame-relay lmi-type ansi

!

interface Serial0/0.100 point-to-point

description lexington to host

bandwidth 256

ip address 192.168.0.22 255.255.255.252

no cdp enable

frame-relay interface-dlci 100 IETF

thanks,

Chris

Re: Bandwidth upgrade

Hi Chris,

No, the bandwidth command is used by routing protocols, QoS and other tools, it doesn't control the physical speed of the interface, the CSU/DSU connected to this interface controls the speed, i guess your provider will do this for you.

HTH,

Mohammed Mahmoud.

Re: Bandwidth upgrade

The only change required to use the full T1 is to enable the service module t1 timeslots all command.

int s0/0

service-module t1 timeslots all

HTH

Sundar

Re: Bandwidth upgrade

Sundar,

You are totally correct, i've missed that this is a channelized interface, and Chris please make sure that your provider has modified the T.S configuration on the CSU/DSU to match yours.

HTH,

Mohammed Mahmoud.

Community Member

Re: Bandwidth upgrade

thanks everyone for the replies!

172
Views
0
Helpful
6
Replies
CreatePlease to create content