Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Bandwidth

i created a rate limit profile for 2Mbps

CIR=2Mbps or 2072576bps

Commited Burst=CIR/16

Excess burst=Commited Burst*2.5

I applied this policy on my interface and I can only get Max 1.6Mbps.

Any suggestions to increase it to atleast 1.97Mbps for a CIR of 2Mbps

  • WAN Routing and Switching
1 ACCEPTED SOLUTION

Accepted Solutions

Re: Bandwidth

Hi,

Are you doing CAR or MQC based policing? MQC is better and recommended method by Cisco.

To police at 2 mbps you need a config like this one. Configure the variables, shown within the brackets, according to your requirements.

class-map match-all

match access-group <100>

!

!

policy-map

class

police 2000000

int s0/0

service-policy input

access-list <100 permit tcp any any eq http>

HTH

Sundar

3 REPLIES

Re: Bandwidth

Hi,

Are you doing CAR or MQC based policing? MQC is better and recommended method by Cisco.

To police at 2 mbps you need a config like this one. Configure the variables, shown within the brackets, according to your requirements.

class-map match-all

match access-group <100>

!

!

policy-map

class

police 2000000

int s0/0

service-policy input

access-list <100 permit tcp any any eq http>

HTH

Sundar

New Member

Re: Bandwidth

Hi,

What MQC

Can you please explain in detail. Because I haven't come across it. I have explain it to someone so that we could set up this scenario

Thanks

Re: Bandwidth

102
Views
0
Helpful
3
Replies