Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

bandwithlimit on a egress port - cat2960

hi,

i have a 2960 switch, on whic i have to limit the bandwith on port fa0/25 to 100kb/s.

i tried the command "srr-queue bandwith limit 10" and defined "bandw 1000" on the fa0/24.

so 10% of 1000kb/s is 100kb/s - but there was no effekt

any idea ?

4 REPLIES
Hall of Fame Super Gold

Re: bandwithlimit on a egress port - cat2960

Hi,

Switches are not the best tool to limit bandwidth. Sometime they work, sometime they don't.

I suggest you use a router to limit bandwidth, or make this question again in the LAN forum (this one is WAN0.

Re: bandwithlimit on a egress port - cat2960

New Member

Re: bandwithlimit on a egress port - cat2960

hi,

thanks for answer.

i configured it like it is described with the

"srr-queue bandwidth limit" command.

the problem ( i think) is that the switch does not react on the "bandwith" command.

it always says it is a 100mb/s interface and

the range for limiting is from 10 to 100%

so the minimum bandwidth i can shape is 10mb/s.

does anybody know if this is right or is there a command where the switch looks at the "bandwith" command ??

thanks for any answer

New Member

Re: bandwithlimit on a egress port - cat2960

Hi rabeder,

The 2960 should support "srr-queue bandwidth limit" however you're correct in saying that the minimum rate is 10% so the lowest you can shape to is 1Mbps if you force the interface to 10Mbps full duplex.

"srr-queue bandwidth limit" limits based on a percentage of the physical line rate - it is not related to the "bandwidth" interface command.

If you want shaping to a granularity of 100kbps then you should be looking at a router to do this as mentioned by p.bevilacqua.

Regards,

Brad

Ratings appreciated.

293
Views
4
Helpful
4
Replies