Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Basic QOS for RDP

Hi,

Im trying to setup a qos policy to control bandwidth for microsoft terminal services so that it will always take priority over other traffic across a link on a cisco 1900 ISR.

Could someone point me in the correct location for a qos novice or give me an example config 

Thanks in adv                 

Everyone's tags (1)
1 REPLY
Super Bronze

Re: Basic QOS for RDP

Disclaimer

The  Author of this posting offers the information contained within this  posting without consideration and with the reader's understanding that  there's no implied or expressed suitability or fitness for any purpose.  Information provided is for informational purposes only and should not  be construed as rendering professional advice of any kind. Usage of this  posting's information is solely at reader's own risk.

Liability Disclaimer

In  no event shall Author be liable for any damages whatsoever (including,  without limitation, damages for loss of use, data or profit) arising out  of the use or inability to use the posting's information even if Author  has been advised of the possibility of such damage.

Posting

You might first see whether just fair-queue is sufficient, e.g.

policy-map sample

class class-default

fair-queue

int x

service-policy output sample

If not, then you can try this generic policy, but you'll need to match your RDP (which might use ACL and/or NBAR).

class-map match-any foreground

match

policy-map sample2

class real-time

priority percent 30

class foreground

bandwidth remaining percent 89

fair-queue

class background

bandwdith remaining percent 1

fair-queue

class class-default

bandwidth remaining percent 9

fair-queue

In sample2, be very careful what traffic you match for real-time and foreground.  Such traffic shouldn't be very bandwidth demanding, and it shouldn't be delayed relative to other traffic. The background class might be used for non-time-critical bulk data transfers, e.g. FTP.  Basically, most traffic will continue to use class-default except when you need or desire to prioritize or deprioritize.

411
Views
0
Helpful
1
Replies
CreatePlease login to create content