Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Basic T1 Configuration for Cisco Router to Juniper Router

Hi All!

   I've never done this before. Hope someone can help.

   What is the very basic config example that we will need to do on our Cisco router to get to communicate to a Juniper router (T1 connection).

Thanks all!

Tom

1 REPLY
New Member

Basic T1 Configuration for Cisco Router to Juniper Router

Tom,

I'd start with the link protocol and choose PPP between them both. You'll then need to make some decisions regarding the routing protocol, OSPF or BGP; would be obvious selections.

in the serial interface

int serX

encapsulation ppp

ip address X.X.X.X 255.255.255.252

no shutdown

router ospf 1

network X.X.X.X 0.0.0.3 area 0

I don't think that the Juniper config will be much different.

I hope that gets you started.

Tony

626
Views
0
Helpful
1
Replies
CreatePlease to create content