Routing

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

Don't miss this Cisco Catalyst 8000 offer

 
Labels

Forum Posts

Finding accurate answers to your questions and issues is always gratifying, but what if these answers are shared globally across different languages? The Cisco Community team has been working on a proof of concept (PoC) to take Accepted Solutions in...

translator.png Asolution.png htlm-source.png insertcode(1).png
Kelli Glass by Community Manager
  • 10013 Views
  • 7 replies
  • 16 Helpful votes

Hello,I wanted to know if: Can you designate an IP address from a BVI interface as a Default Gateway to all kinds of end point devices connected to any of the interfaces belonging to the bridge group?Should it  be possible to ping that interface from...

axel-r by Level 1
  • 74 Views
  • 1 replies
  • 0 Helpful votes

Hello everyone,Currently seeking assistance in identifying the issue.We have two ASR 9006 routers located at two different sites. Both routers are running OSPF between them, utilizing multiple sub-interfaces, with each sub-interface assigned to a dif...

blitzperf_0-1711348818564.png
blitzperf by Level 1
  • 190 Views
  • 4 replies
  • 0 Helpful votes

Hello,My datacenter will be move to other location, and we want to minimize the downtime. what in my mind is i will set up a new server with the network in a new location and i will migrate my virtual server one by one from old location to new locati...

hs08 by Spotlight
  • 107 Views
  • 1 replies
  • 0 Helpful votes

Hi, We have a bunch of 2911 and 4331 (and a few 2800 left) routers in branch offices around the world. Is there a way to get these routers to log when port errors occur? Like any input/output interface errors, especially CRC/FCS? Or is the only optio...

Tboss99 by Level 1
  • 2176 Views
  • 6 replies
  • 0 Helpful votes

Hello Cisco Community.I hope I could make myself clear, cause my homelanguage isn' t english.I have SG350-28P and two internet connection, witch connected with Mikrotik router, witch doing NAT.My goal:Mikrotik 1 - let' s say vlan10 and 192.168.0.1/24...

Hi there, I've following BGP setup: AS A        PE1  - - - - - - PE2                  |                        |                  |                        | AS B       CE1 ---------- CE2 I run bgp, eBGP between CE1/CE2 and PE1/PE2 and iBGP between CE...

I set up a C1121-4P router for a friend with int gig0/0/0 facing the ISP with ip address dhcp. int gig0/0/1 192.168.1.1/24. See attached sh run. Vanilla Configuration not much security or complexity. After a power reload the GUI "https://192.168.1.1/...

Hi There,i am struggling a bit with our BGP Configuration and hopefully someone can give me a hint to right direction.We have 3 Routers in iBGP each of them has a WAN Connection to external AS (eBGP).Currently all Traffic is routed to only 1 external...

AS789 by Level 1
  • 280 Views
  • 7 replies
  • 1 Helpful votes

Hello everyone!A bit of topology background: I currently have two edge routers facing IX's. Behind the two edge routers, I have two core routers. These core routers are connected to other routers running OSPF and iBGP.Please refer to the sample topol...

blitzperf by Level 1
  • 191 Views
  • 2 replies
  • 0 Helpful votes