Routing

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

Don't miss this Cisco Catalyst 8000 offer

 
Labels

Forum Posts

Finding accurate answers to your questions and issues is always gratifying, but what if these answers are shared globally across different languages? The Cisco Community team has been working on a proof of concept (PoC) to take Accepted Solutions in...

translator.png Asolution.png htlm-source.png insertcode(1).png
Kelli Glass by Community Manager
  • 10030 Views
  • 7 replies
  • 16 Helpful votes

Using cisco isr4300 routers. Have a simple 3-way triangle between 3 routers:RtrA--RtrB |        / |      /RtrCStatic route on RtrA & RtrB pointing to a RtrC loopback, via their adjacent links.Default route on RtrC point to RtrA.No routes exist on Rtr...

will by Level 3
  • 165 Views
  • 4 replies
  • 0 Helpful votes

i just swapped out a 3850 POE switch to a 3850 non-poe.  i upgraded the OS to 16.6.9.  then i copied the config back to the new non-poe switch.  now i cant ping or access the switch via the network.  constantly getting %SPANTREE-2-UNBLOCK_CONSIST_POR...

Bonjour,J'ai un VLAN bureautique en 192.168.1.0. Mon CBS350-8T-E-2G a l'adresse 192.168.1.240.La passerelle par défaut est le 192.168.1.1.J'ai un VLAN formation en 192.168.80.0. Mon CBS350-8T-E-2G a l'adresse 192.168.80.1, le dhcp fonctionne parfaite...

Dear Expert,Hope all is well.One of cisco route 2921 reboot it unexpectedly and upon checking, we find out below result:cisco router reload reason bus error at PC 0xB0D0B0D, address 0x0.the firmware version: c2900-universalk9-mz.SPA.157-3.M8.binthank...

Hello,I wanted to know if: Can you designate an IP address from a BVI interface as a Default Gateway to all kinds of end point devices connected to any of the interfaces belonging to the bridge group?Should it  be possible to ping that interface from...

axel-r by Level 1
  • 74 Views
  • 1 replies
  • 0 Helpful votes

Hello everyone,Currently seeking assistance in identifying the issue.We have two ASR 9006 routers located at two different sites. Both routers are running OSPF between them, utilizing multiple sub-interfaces, with each sub-interface assigned to a dif...

blitzperf_0-1711348818564.png
blitzperf by Level 1
  • 192 Views
  • 4 replies
  • 0 Helpful votes

Hello,My datacenter will be move to other location, and we want to minimize the downtime. what in my mind is i will set up a new server with the network in a new location and i will migrate my virtual server one by one from old location to new locati...

hs08 by Spotlight
  • 109 Views
  • 1 replies
  • 0 Helpful votes

Hi, We have a bunch of 2911 and 4331 (and a few 2800 left) routers in branch offices around the world. Is there a way to get these routers to log when port errors occur? Like any input/output interface errors, especially CRC/FCS? Or is the only optio...

Tboss99 by Level 1
  • 2181 Views
  • 6 replies
  • 0 Helpful votes