Hi, I have 512kbs link. I have to implement qos. My CIR with ISP is 300Kbs & max burst allowed is 12 kbs in time of congestion. What would be my Be & Bc value. I am totally confused with Be value. Please help
Here are some quick notes for you. Hope they help...But basically you would set the BC (burst committed) value to change the TC (Timer interval). You would want to change the TC for low latency applications. You change the BC to indirectly change the TC. I think the lowest at this point is 10ms you can get.
TC - Time interval /ms
BC - Burst committed
Be - burst excess (default will be what the BC is configured)
BC/TC = CIR per second
1000ms = 1 second
tc/1000 = seconds
BC = CIR*TC/1000 - Formula to calculate to figure out what the BC can be for the CIR
TC = going to be indirectly set by the BC
Why do you need to change the BC?
- Low delay applications
BE - set for 12 kbs
CIR - 300k
BC - can set for default depends on your needs
TC - cant change but will default based off BC
use the following formula to calculate - BC = CIR*TC/1000
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...