Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Best device to fit for a project

I'm not sure this is the right section but I try.

For a project (less than 100 branch offices and 2 Headquarters connected in an hub&spoke topology with IPSEC over MPLS among branch and HQ)

I’m looking for the best device which cover the following items:

Branch:
Single device
At least two Ethernet interfaces (WAN/LAN)
Ipsec supporting 10-50-100 Mbs 3DES
Routing protocols such as BGP-OSPF
NAT
Redundant power supply (some site not but in principle I need it)

HeadQuarter:
Single device with TenG intf
At least two XEthernet interfaces (WAN/LAN)
IPSEC supporting up to 7-10 Gbs of IPSEC 3DES (the sum of branches)
Routing protocols such as BGP-OSPF
NAT
Redundant power supply

Firewall policy are not needed, MPLS will be runned by two carrier (this is why single device, there will be two single devices (with hsrp/vrrp) per site each one connected to one MPLS carrier), IPSECs tunnels are on-top of MPLS.


I’m looking for the best solution in terms of scalability and price (very important).

I've an idea in my mind but I'd like to share your experience for the decision...

Regards

3 REPLIES
New Member

Your best bet might be to

Your best bet might be to speak to a reseller, they should be able to give you some ideas

New Member

Thanks for the raccomendation

Thanks for the raccomendation, here there is the experience, reseller sells a lot of things...

 

Hall of Fame Super Gold

Duplicate posts.    Go here:

Duplicate posts.   cheeky

 

Go here:  http://supportforums.cisco.com/discussion/12161946/best-device-fit-project

50
Views
0
Helpful
3
Replies
CreatePlease login to create content