10-29-2009 02:11 AM - edited 03-04-2019 06:32 AM
How to configure BFD on tunnel interface (MPLS traffic engineering tunnel) for XR and IOS devices ? Please help....
10-29-2009 04:46 AM
Pramod,
If your requirement is to use BFD for FRR, you dont need to enable BFD on tunnel interface.
You need to configure "ip rsvp signalling hello bfd" command to enable BFD for MPLS TE FRR.
If you have a different requirement, let us know.
HTHT,
Nagendra
10-29-2009 06:29 AM
here is the output for bfd neighbors
Router#sh bfd neighbors
OurAddr NeighAddr LD/RD RH/RS Holddown(mult) State Int
150.1.1.2 150.1.1.1 1/2 Up 0 (3 ) Up PO6/0
Router#
from above output instead on POS6/0 i need tunnel interface ! Is it possible
similary
XR device also
RP/0/4/CPU0:ios#show bfd session
Interface Dest Addr Local det time(int*mult) State
Echo Async
-------------------- --------------- ---------------- ---------------- ---------
PO0/0/0/2 150.1.1.2 150ms(50ms*3) 6s(2s*3) UP
RP/0/4/CPU0:ios#
instead of pos0/0/0/2 i need tunnel-te!
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide