Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

BFD on MPLS traffic engineering tunnel

How to configure BFD on tunnel interface (MPLS traffic engineering tunnel) for XR and IOS devices ? Please help....

2 REPLIES
Cisco Employee

Re: BFD on MPLS traffic engineering tunnel

Pramod,

If your requirement is to use BFD for FRR, you dont need to enable BFD on tunnel interface.

You need to configure "ip rsvp signalling hello bfd" command to enable BFD for MPLS TE FRR.

http://www.cisco.com/en/US/docs/ios/mpls/configuration/guide/mp_te_bfd_frr_ps6922_TSD_Products_Configuration_Guide_Chapter.html

If you have a different requirement, let us know.

HTHT,

Nagendra

New Member

Re: BFD on MPLS traffic engineering tunnel

here is the output for bfd neighbors

Router#sh bfd neighbors

OurAddr NeighAddr LD/RD RH/RS Holddown(mult) State Int

150.1.1.2 150.1.1.1 1/2 Up 0 (3 ) Up PO6/0

Router#

from above output instead on POS6/0 i need tunnel interface ! Is it possible

similary

XR device also

RP/0/4/CPU0:ios#show bfd session

Interface Dest Addr Local det time(int*mult) State

Echo Async

-------------------- --------------- ---------------- ---------------- ---------

PO0/0/0/2 150.1.1.2 150ms(50ms*3) 6s(2s*3) UP

RP/0/4/CPU0:ios#

instead of pos0/0/0/2 i need tunnel-te!

1526
Views
0
Helpful
2
Replies
CreatePlease to create content