I agree with Alain that more information about how your router is configured would be helpful. And in addition to some configuration details it might be helpful if you would post the output of show ip route.
Thanks for posting back to the forum to tell us that you had found the problem and had fixed it. Sometimes it is helpful for us to be reminded of the importance of checking fundamental setup when we run into a problem. Also thanks for the rating.
[toc:faq]The ProblemOn traditional switches whenever we have a trunk
interface we use the VLAN tag to demultiplex the VLANs. The switch needs
to determine which MAC Address table to look in for a forwarding
decision. To do this we require the switch to do...
[toc:faq]Introduction:Netdr is a tool available on a RSP720, Sup720 or
Sup32 that allows one to capture packets on the RP or SP inband. The
netdr command can be used to capture both Tx and Rx packets in the
software switching path. This is not a substitut...
IntroductionOSPF, being a link-state protocol, allows for every router
in the network to know of every link and OSPF speaker in the entire
network. From this picture each router independently runs the Shortest
Path First (SPF) algorithm to determine the b...