BGP aggregate-address

[bellocarico]

What is the difference in using an attribute-map instead of a route-map as paramenter of the

bgp aggregate-address command?

From the "?"

attribute-map Set attributes of aggregate

route-map Set parameters of aggregate

Thanks to read.

[owaisberg]

Hello,

attribute-map and route-map are equivalent

and do the same job, so no difference whatsoever beside the name.

HTH,

OW

* Please rate all useful posts

[royalblues]

Friend,

Though they perform the same thing, it should be noted that the attribute-map command can only be used along with the aggregate command and it references a route-map

Whereas the route-map can be used with almost anything for implementing the routing policy.

HTH, rate if it does

Narayan

[owaisberg]

Narayan,

You are correct, however original question

was about the difference between these two

commands when both used with aggregate.

And as per aggregate usage, these two are

identical.

HTH,

OW