Pls Could you explain the following BGP Community tags scenario ?
3 Routers r1, r2 & r3 are in Different BGP AS.
R1 --- AS 1
R2 --- AS 2
R3 --- AS 3
R1 establishes EBGP with R2 & R3
NOW The below networks are advertised under BGP on R2 & R3
R2 : 18.104.22.168/24, 22.214.171.124/24
R3 : 126.96.36.199/24, 188.8.131.52/24
NOW Ensure that R1 uses AS 2 to connect to 184.108.40.206/24 & 220.127.116.11/24 & AS 3 to 18.104.22.168/24 & 22.214.171.124/24. WE must use use community tags in AS 2 & 3 and neighbor command on R1 to accomplish this task.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...