the same AS number is used in CE1 & CE2 so they will not accept routes coming from the same AS number so you need to configure: neighbor x.x.x.x as-override into PEs ISP routers under address-family ipv4 vrf Customer1 so the PE will send bgp update with AS [200 200] instead of [200 100] and you can also use allow-as into CE router but by the two cases it is recommended to configure SOO if there a backdoor link or the site is connected to more than one PE router to avoid routing loops.
We are pleased to announce availability of Beta software for 16.6.3.
16.6.3 will be the second rebuild on the 16.6 release train targeted
towards Catalyst 9500/9400/9300/3850/3650 switching platforms. We are
looking for early feedback from customers befor...
Introduction Featured Speakers Luis Espejel is the Telecommunications
Manager of IENova, an Oil & Gas company. Currently he works with Cisco
IOS® and Cisco IOS XE platforms, and NX to some extent. He has also
worked as a Senior Engineer with the Routing P...
In this session you can learn more about Layer 3 multicast and the best
practices to identify possible threats and take security measures. It
provides an overview of basic multicast, the best security practices for
use of this technology, and recommendati...