Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

BGP CONFIGURATION

hi, i have the atach confirud in my router for working with BGP, i has tow service provider when one of then get 100% of bandwich i the other is 20 % more or less i want to use the both in the same i mean load balance can some one suggest something to change or to add. thanks

1 REPLY

Re: BGP CONFIGURATION

When there are parallel, equal-cost paths to a particular destination use the command Maximum paths under the BGP process

to load balance

Note that load balancing works only with EBGP.

HTH, rate if it does

Narayan

117
Views
0
Helpful
1
Replies