184.108.40.206 (metric 297246976) from 172.31.192.82 (172.31.255.12)
Origin IGP, metric 1, localpref 100, valid, internal, best
It shows the bgp advertisement that it received from PHIL from 172.31.192.2(loopback 172.31.255.2)
And it shows the advertisements it received from the 2 route-reflectors, 172.31.192.90 and 172.31.192.82.
I don't see why it picked the route that it did; i thought it should have picked the rouute from PHIL, 172.31.192.2
Next hop and Sync - OK
Weight - 0 for all 3
Local pref - 100 for all 3
#4 AS path - same for all 3
#5 Origin - IGP for all 3
#6 MED - either 297246976 or 1, not sure how to read it, but equal for all 3
#7Prefer EBGP over IBGP - all are IBGP
#8 Prefer the path with the lowest IGP
metric to the BGP next hop - is this shown in the output? This may be the decision point -- not sure how this is measured, as going thorugh PHIL the cost to the endpoint is the highest, but since this is EIGRP internally, does this use the eigrp topo table to check and see if it is using that particular neighbor to get to the BGP next hop?
#9 - multipath
#10 When both paths are external, prefer the path that was received first (the oldest one). not applicable
#11 Prefer the route that comes from the BGP router with the lowest router ID. picks 172.31.255.12 instead of .12 (but I'm still not sure why it didn't pick the advertisement originally from .12 and out of our PHIl core router).
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.