Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

BGP Multihomed with single /24

If having a single /24 allocated address space, can i split this into smaller subnets so that half of the subnet preferred to ISP1 and half to ISP2 as the primary path respectively? and should there will be link failure, convergence routes via iBGP peer towards the peering ISP?

7 REPLIES

Re: BGP Multihomed with single /24

why do you want to split it???? I have 4 data centres each advertise a single /24 to dual independent isp's works well for me, :o)

Sent from Cisco Technical Support iPad App

New Member

BGP Multihomed with single /24

The idea behind of load-sharing the traffic  ...

Super Bronze

BGP Multihomed with single /24

Disclaimer

The Author of this posting offers the information contained within this posting without consideration and with the reader's understanding that there's no implied or expressed suitability or fitness for any purpose. Information provided is for informational purposes only and should not be construed as rendering professional advice of any kind. Usage of this posting's information is solely at reader's own risk.

Liability Disclaimer

In no event shall Author be liable for any damages whatsoever (including, without limitation, damages for loss of use, data or profit) arising out of the use or inability to use the posting's information even if Author has been advised of the possibility of such damage.

Posting

For outbound, if your devices support it, have you examined OER/PfR?

New Member

BGP Multihomed with single /24

yeah i'm using OER

Silver

BGP Multihomed with single /24

Gerard Gacusan wrote:

If having a single /24 allocated address space, can i split this into smaller subnets so that half of the subnet preferred to ISP1 and half to ISP2 as the primary path respectively? and should there will be link failure, convergence routes via iBGP peer towards the peering ISP?

Most ISP's will not accept anything smaller than a /24 in advertisement - so no, you won't be able to advertise say a /25 out one ISP and another /25 out the other.

However, if you advertise the whole /24 to both uplinks at the same precedence, and without any prepending, then traffic will come in via the 'best" path from its originating point. That's about all you can do with incoming data, really - even if you prepend and give one link a much higher precedence, there will always be *some* traffic which will come in over the second link simply because the "path" to your terminating point is shorter.

If you want to control how your *outbound* data flows, then as Joseph has suggested, you should look into OER/PfR - I've explored this recently for a similar situation, and will be implementing it as soon as I can get a change window approved.

New Member

Re: BGP Multihomed with single /24

yeah i agree ... i tried prepending and bgp looking glass tells me the whole /24.

i advertised /24 on both ISP's and i have no problem with that.

New Member

BGP Multihomed with single /24

You'll probably have this as well but just in case, here's a good read.

http://docwiki.cisco.com/wiki/PfR:Solutions

BGP community is an other option.

450
Views
0
Helpful
7
Replies