In my senario i have BGP configured between two routers. i have mutihop configured in this BGP because it going through a firewall passing through a VPN tunnel at the other end its comes of the VPN tunnel and forms the neighbors. Its all working.
But, for some reason i need to change the update-source IP address at site A. so in my configuration the local IP is nated on the firewall before entering the VPN tunnel. (i dont have permision to do any IP changes at Site B BGP configuration)
My issue is because i configured the MD5 password for BGP authentication the BGP status is Active but, when i remove the password at both end the BGP is forming Neighbhors.
Why does MD5 not working via the NATed configuration. Is it using the local IP address ( not the nated address) of the BGP configuration for MD5 authentidation which is not recogonised at the other end.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.