I have a BGP router learned a route through two way:one through eBGP,one through iBGP.For I preferred the iBGP path so I use route-map to set the eBGP route's origin to incomplete(the ORIGIN attribute has a higher priority in the decision process than IBGP/EBGP),but when I "show ip bgp",the router still preferred the incomplete route.What's reason?
Sugarbush#sh ip bgp 192.168.192.0 255.255.248.0
BGP routing table entry for 192.168.192.0/21, version 50
Paths: (2 available, best #1, table Default-IP-Routing-Table)
Advertised to non peer-group peers:
100, (aggregated by 100 172.16.0.21)
192.168.1.254 from 192.168.1.254 (172.16.0.21)
Origin incomplete, metric 0, localpref 100, valid, external, atomic-aggregate, best
100, (aggregated by 100 192.168.50.254)
192.168.1.245 (inaccessible) from 192.168.1.237 (192.168.255.253)
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...