I am trying to setup BGP between our primary isp and the backup isp . We have our own AS number and a netblock that we would like to advertise . I would like to setup BGP in such a way that i will be advertising a /24 bit route to the BGP cloud and the ISP will only advertise a default route to US . Also i would like to setup HSRP between the two ISP CPE routers so that the primary ISP router will have a higher standby priority and the backup isp router has a lower standby priority .I have the following two questions regarding BGP setup in this scenario :
1) Do i need to setup IBGP peeing between the primary ISP CPE and the backup ISP CPE router if i am not planning load balance between the two ISP's?
2) What is the preferred or the best way of configuring HSRP tracking ? As far as I know we could track the physical interface , line protocol , track ip route and ping an ip . I would like to know which is the preffered way of tracking HSRP .
Thank you , so i would need to setup IBGP between the primary ISP CPE and the secondary ISP CPE eventhough both the ISP CPE routers are in the same building and same physical network ? Do you know why this is required ? I am trying to understand why an IBGP setup is required between the primary ISP CPE and the backup ISP CPE .
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...